How About Cutting Metal With A Precision Metal Laser Cutter?

Sep 28, 2020
How About Cutting Metal With A Precision Metal Laser Cutter?

Precision metal laser cutting machine has a variety of ways: in addition to the use of plate cutting machine, combined punching and cutting machine, longitudinal cutting machine, water cutting machine, etc., there are also plasma cutting machine, laser cutting machine and other hot cutting equipment.Among them, the precision metal laser cutting machine is the numerical control system, can be cut in the thin plate, depict the complex pattern, the precision is very good, can also be applied to the metal thick plate cutting, has been widely used in the field of sheet metal processing!Cutting stainless steelThe use range of stainless steel is very wide, like kitchen equipment, general stretch material, gas stove, refrigerator, electrical appliances, washing machine, building materials, regrinding, elevator, building interior and exterior decorative materials, chemical equipment, heat exchanger, boiler, you can see the figure of stainless steel!Stainless steel adopts precision metal laser cutting, not only the cost is lower than the traditional wire cutting, but also the speed is twice of the wire cutting, can achieve mass production, is a fast and effective processing method!



Precision metal laser cutting machine stainless steel cutting samples


Precision metal laser cutting machine is widely used in carbon steel cutting, carbon steel precision metal laser cutting machine has the advantage of cutting arbitrary design graphics on the plate, fast speed, high precision, one molding, no subsequent processing. And laser cutting machine cutting carbon steel without casting, save cost, visual discharge, close fitting, save material.



Precision metal laser cutting machine for cutting carbon steel samples


Precision metal laser cutting machines can also be used to cut non-ferrous metals (copper and brass). Both materials have high reflectivity and very good thermal conductivity. Brass of less than 1mm thickness can be cut and processed with nitrogen laser; Copper with thickness less than 2mm can be cut. Oxygen must be used for laser cutting. It should be noted that when cutting copper and brass, a "reflection absorption" device should be installed on the system.