How About Precision Metal Laser Cutting Machine Cutting Metal?

Dec 25, 2020
How About Precision Metal Laser Cutting Machine Cutting Metal?

There are many methods for precision metal laser cutting machines: in addition to using plate shears, combined punching and shearing machines, slitting machines, water cutting machines, etc., there are also thermal cutting equipment including plasma cutting machines and laser cutting machines.

Among them, the precision metal laser cutting machine adopts a numerical control system, which can cut and depict complex patterns on thin plates with excellent accuracy. It can also be applied to cutting thick metal plates and has been widely used in the field of sheet metal processing!

Cutting stainless steel

Stainless steel is used in a wide range, such as kitchen equipment, general drawing materials, gas stoves, refrigerators, electrical appliances, washing machines, building materials, regrinding, elevators, interior and exterior decorative materials for buildings, chemical equipment, heat exchangers, boilers, etc. You can see the figure of stainless steel!

Stainless steel is cut by precision metal laser, not only the cost is lower than traditional wire cutting, but also the speed is twice that of wire cutting, which can realize mass production and is a fast and effective processing method!

Stainless Steel Sutting Samples

Precision metal laser cutting machine is widely used in carbon steel cutting. The advantage of carbon steel precision metal laser cutting machine is that it can cut any design pattern on the plate, with fast speed, high precision, one-time forming without subsequent processing. In addition, the laser cutting machine cuts carbon steel without casting molds, which saves costs, visually arranges the material, fits closely, and saves materials.

Carbon Steel Cutting Samples

Precision metal laser cutting machines can also be used to cut non-ferrous metals (red copper and brass). Both materials have high reflectivity and very good thermal conductivity. Brass with a thickness of 1mm or less can be cut with nitrogen laser; copper with a thickness of 2mm or less can be cut, and the laser cutting gas must use oxygen. It should be pointed out that when cutting copper and brass, a "reflection absorption" device must be installed on the system.